Refurbished and Remanufactured C-Arms
 Download OEC 9400 PDF Brochure
 All c-arms undergo a multistep remanufacturing process. We take great pride in the fact that each unit is restored to a like-new status. Pain Management, Orthopaedics, Rehabilitation Services are just a few of the applications utilizing these remanufactured c-arms. The rotating x-ray tube allows for greater penetration and resolution for the lumbar area when doing needle localizations or other work involving the thicker anatomical areas of patients. For barium swallows a VCR or Digital Video Recorder can be utilized for better record keeping and post study analysis. The 1K X 1K CCD Technology used in this image system allows for crisp clear imaging. Whatever the purpose, any of these remanufactured c-arms will deliver the results you can depend on.
Mechanical repairs/cosmetic maintenance
- All defective parts and covers are repaired or replaced
- C-arm is completely disassembled and repainted
- “C” is removed from main frame assembly
 Download OEC 9600 PDF Brochure
- Horizontal arm removed, inspected and repaired as necessary
- Vertical column removed and bearings removed inspected and replaced as required
- X-ray tube removed and inspected for artifacts and internal integrity
- Image intensifier removed and inspected for any imperfections and grid integrity
- Camera removed
- Wheels removed, cleaned and or replaced from main chassis
- Chassis inspected for structural defects and repaired as necessary
- Vertical lift assembly is tested for drift and adjusted/replaced if necessary
- All bearings are inspected, cleaned and re-lubricated, or replaced as needed
- Control panel display is tested and replaced if necessary
- All wheels are inspected and lubricated and/or replaced as needed, with new cable pushers installed
- All locks and brake assemblies are inspected, cleaned, and repaired or replaced as needed
- C-arm is completely disassembled and repainted
- Steering is tested and adjusted is required
- Foot switch and hand switch provided on each unit
- A complete set of operator and service manuals are provided
 Re-assembly
- All components sent to C-arm reassembly area for rebuilding
- “C”, Image tube and camera,
- Vertical column, main control and power cable installed
- New batteries are installed
- New CRT monitors installed in monitor cart
- Monitor cart rebuilt
- When C-arm is completely rebuilt mechanically system is sent for calibration and final testing
Download OEC 9800 PDF Brochure
|
